Shop all categories

Elmer's Multi-Purpose Spray Adhesive

Elmer's Multi-Purpose Spray Adhesive
$
4.99$1.25 / oz.
Limit 6 per order
Quantity
Add to Basket

Find this item at a nearby store

Enter ZIP code or location

Elmer's Multi-Purpose Spray Adhesive
4 OZ, 0 lbs. Item # 492688

Allows For Repositioning Dries Permanent Fast Tack, Dries Clear

Resists "Bleed Through" Acid Free, Photo Safe

With Wide Pad Nozzle For No-Mess Application

Spray Adhesive Great For:

  • Photos
  • Fabrics
  • Paper
  • Glass
  • Foil
  • Cork
  • Metal
  • Plastics
  • Wood
  • Films
  • Felt
  • Cardboard
  • Canvas
  • Leather
  • Rubber
  • Foams

Not recommended for use on vinyl materials or automotive headliners.

USES: Elmer's "fast tack" Spray Adhesive is a strong, water-resistant adhesive which provides a permanent or temporary bond on a wide variety of materials. Will not swell or warp. Resists "bleed-through".

FIRST AID TREATMENT: If eye contact occurs, rinse with tap water for 5-10 minutes. If irritation persists, seek medical care. If inhalation symptoms occur, move to fresh air. If symptoms persist, see a physician.

For further health information contact a poison control center or call 1-888-516-2502.

CARB Category: Mist Spray Adhesive.

VOC content is less than 65% by weight.

No lead in formula; No fluorocarbons; No methylene chloride; No hexane; No methoxy or ethoxyethanol or their acetates.

This product was manufactured for and intended for consumer use.
It is labeled according to the Federal Hazardous Substances Act.
Should product be used in the workplace, Material Safety Data Sheets may be obtained at www.elmers.com.

Directions

PREPARATION:
 

  • Shake can well before using. Protect surrounding area from overspray (dried adhesive will remain slightly tacky).
  • Point spray button opening away from you with can 6 to 8 inches from surface to be bonded. Spray an even coat. Important! To avoid possible clogging, turn the can upside down and spray a short jet of clear gas after completing job.

APPLICATION: For Temporary Bonds: Spray a light coat and allow to dry for 3-5 minutes before joining. To remove, work a corner loose and peel back.

For Permanent Bonds: Join surfaces within 15 seconds while adhesive is still tacky. Allow to set at least one hour.

Warnings

Note: Do not use for bonding heavy materials.

DANGER: EXTREMELY FLAMMABLE. CONTENTS UNDER PRESSURE. VAPOR HARMFUL. EYE IRRITANT.
SEE BACK PANEL.

Contains: ACETONE. Do not puncture or incinerate or expose to temperatures above 120 Degrees F (50 Degrees C).
PRECAUTIONS: Do not smoke when using. Keep away from eyes. Avoid contact with heat, sparks and open flame. Vapors can ignite explosively. If using indoors turn off all pilot lights. Do not store or use near heat or flame.

KEEP OUT OF REACH OF CHILDREN. Use only with adequate ventilation.
Prices may vary from online to in store.
*Customer reviews and ratings solely reflect the views and opinions of the individual contributors and are not created or endorsed by CVS Pharmacy. Please review the product labeling and consult with your doctor with any health or medical questions.